| Mullite Mullite is a good, low cost refractory material with a nominal composition of 3Al2O3•2SiO2.
The raw materials are easily obtainable and are reasonably priced. It
has excellent high temperature properties with improved thermal shock
and thermal stress owing to the low thermal expansion, good strength
and interlocking grain structure. | .Key Properties |  | Good thermal shock and stress resistance | | Low thermal conductivity | | Good strength | | Wear resistant | | Usable to high temperatures | .
Typical Uses | | Protection tubes | | Furnace liners | | Electrical insulators | Back to top Engineering Properties* | Mullite — Cast and Extruded | | Mechanical | Units of Measure | SI/Metric | (Imperial) | | Density | gm/cc (lb/ft3) | 2.8 | (175) | | Porosity | % (%) | 0 | 0 | | Color | — | off-white | off-white | | Flexural Strength | MPa (lb/in2x103) | 180 | (26) | | Elastic Modulus | GPa (lb/in2x106) | 151 | (22) | | Shear Modulus | GPa (lb/in2x106) | — | — | | Bulk Modulus | GPa (lb/in2x106) | — | — | | Poisson’s Ratio | — | — | — | | Compressive Strength | MPa (lb/in2x103) | 1310 | (190) | | Hardness | Kg/mm2 | 1070 | — | | Fracture Toughness KIC | MPa•m1/2 | 2 | — | Maximum Use Temperature
(no load) | °C (°F) | 1650 | (3000) | | Thermal | | | | | Thermal Conductivity | W/m•°K (BTU•in/ft2•hr•°F) | 6 | (42) | | Coefficient of Thermal Expansion | 10–6/°C (10–6/°F) | 5.4 | (3) | | Specific Heat | J/Kg•°K (Btu/lb•°F) | — | — | | Electrical | | | | | Dielectric Strength | ac-kv/mm (volts/mil) | 9.8 | (245) | | Dielectric Constant | @ 1 MHz | 5.8 | 5.8 | | Dissipation Factor | @ 1 kHz | 0.003 | 0.003 | | Loss Tangent | — | — | — | | Volume Resistivity | ohm•cm | >1013 | >1013 | *All properties are room temperature values except as noted.
The data presented is typical of commercially available material and is
offered for comparative purposes only. The information is not to be
interpreted as absolute material properties nor does it constitute a
representation or warranty for which we assume legal liability. User
shall determine suitability of the material for the intended use and
assumes all risk and liability whatsoever in connection therewith. See also: Ceramic Rod & Tube
See also: Ceramic Rod & Tube > Mullite Sizes Back to top Standard Products | Custom Products and Services | Case Studies | Materials
Design Notes | Working Together | Vision | Contact Us | Site Map 1-908-213-7070 ©2002 Accuratus Site Design M. Adams | 
